Filter
Top Products
Diagram and System Functions
Diagrama y Funciones del Sistema | Schéma & Détail des Fonctions | Bedienfeld
5
MS-USB SETUP GUIDE - EN
DIAGRAM AND SYSTEM FUNCTIONS
4
321
8
765
12
11
10
9
20
15
14
13
17
16
19
18
1. CUE: Sets a return point from which the unit will playblack.
2. PLAY/PAUSE: Pressing this button will alternate between PLAY mode and PAUSE mode. If the unit is in PLAY, pressing this will
PAUSE the unit. If the unit is in PAUSE mode, pressing the button will PLAY the selected track.
3. SEARCH/REWIND: Pressing the SEARCH/REWIND button will rewind the track.
4. LOOP SECTION (IN/OUT): A LOOP repeats the section between the entry point (IN) and the exit point (OUT). To set a loop while the
unit is playing, start by pressing the LOOP IN button (it will light up) and when you reach the desired end loop point press the LOOP
OUT button (it will also light up and both will ash). The loop will continue playing until you press LOOP OUT.
5. REVERSE: Push the REVERSE button to play your track in reverse. Press the REVERSE button again to revert back to normal
playback.
6. RELOOP: Press RELOOP to return to the beginning of the previously saved loop from normal play.
7. SEARCH/FORWARD: Pressing the SEARCH/FORWARD button will advance the track.
8. PITCH CONTROL: Moving the PITCH CONTROL SLIDE up or down will lower or raise the pitch percentage + or - 4%, 8%, or 16%.
9. DISPLAY: The LCD display indicates the Track/Numbers/Time/Remain/Pitch/Continue/Single.USB port:
10. USB Port: Used to connect a USB memory stick.
11. SD Card slot: Used to insert an SD card (SDHC compatible).
12. TIME: Pressing the time button changes the TIME DISPLAY mode between Elapsed time, Remaining time, or Total Remaining time.
13. REPEAT: The REPEAT function allows you to REPEAT one track or the entire track list.
14. SINGLE: The SINGLE function toggles between SINGLE and CONTINUOUS play mode. The selected mode is indicated on the LCD.
In SINGLE mode, the unit will stop after each track. In CONTINUOUS mode, the unit will continue playing tracks.
15. USB/SD: Toggles the audio source between the USB port and the SD card slot.
16. ID3: Pressing the ID3 button displays the name of the song on the LCD display.
17. PITCH BEND (-): Pushing the PITCH BEND (-) will automatically lower the pitch down to -16% and return to the original pitch when
released.
18. PITCH BEND (+): Pushing the PITCH BEND (+) will automatically raise the pitch up to +16% and return to the original pitch when
released.
19. PITCH: Pressing the PITCH button toggles the PITCH CONTROL values between +/- 4%, 8%, and 16%.
20. FOLDER/TRACK SEARCH: The FOLDER/TRACK SEARCH allows you to navigate through folders or tracks. Turn the knob to the
right to advance the selection, or turn the rotary to the left to reverse the selection. Push the knob to engage the selection.