Filter
Top Products
Troubleshooting
Setting and Confirming SCSI Parameters
Chapter 3 79
Setting SCSI ID
To set the initiator SCSI ID for an adapter using the SCSI command, use
the following syntax:
SCSI init
bus_number slot_number ID_number
where
bus_number
Specifies the number of the bus on which the adapter is
installed.
slot_number
Specifies the number of the slot the adapter is in.
ID_num
Specifies the adapter’s SCSI ID number.
For example, to set the SCSI ID for an adapter installed on bus 5 slot 2 to
6, issue the following command:
SCSI init526
To display the result, issue the following command:
SCSI init 5 2
The output is as follows:
PCI device /5.2 = 6