Filter
Top Products
Manual Setup
If the monitor is in power
saving mode, it might
automatically turn off while
you are waiting for it to warm up.
Manual setup is not required when using digital input.
Normally, you can complete the setup procedure using
AUTO SETUP
;
however, if your screen image is still distorted after you perform
AUTO
SETUP or the Installation CD does not run on your system, perform MANUAL
S
ETUP.
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2. Display the image you most frequently use on the screen then go to
windows shut down mode.
3. Press the OSD Enter button MENU at the bottom of the monitor to
display the initial OSD menu.
4. Use the
or button and MENU to select Image Setup then
adjust clock or Focus
(a) "Clock" (pixel frequency) controls the number of pixels scanned
by one horizontal sweep.
If the frequency is not correct, the screen shows vertical stripes
and the picture does not have the correct width.
(b) "Focus" adjusts the Phase of the pixel clock signal. With a wrong
phase adjustment the picture has horizontal disturbances in light
picture.
5. Use the
or button to manually adjust and optimize the screen
quality. Save by pressing the Exit button AUTO once & press 2 more
times to exit the OSD menu.
You have completed monitor setup.
15