Filter
Top Products
JCD3006
7
TUNER OPERATION
Select a Band
Press the B button (19) on the control panel (or the BND button on the remote control) to
change between three FM bands and one AM band. Each band store
s up to six preset
stations.
Tuning
Auto Seek Tuning
Press the up >>| (21) or down |<< button (20) on the control panel (or the U or D buttons on the
remote control) for less than three seconds to move to the next station automatically.
Manual Tuning
Press the up >>| (21) or down |<< button (20) for more than three seconds to enter manual
tuning mode. Press the up >>| (21) or down |<< button to change the radio frequency number
up or down one step. The radio signal strength meter indicates the strength of the current radio
station broadcast.
Scan
Press the SCN button (10) to automatically search for stations. Each available station will flash
on the display for a few seconds before the next is searched. To select a “flashing” station,
press the SCN button again.
Local/Distant (LO/DX)
During radio operation, received signals are usually in stereo mode as indicated by the “ST”
icon; however, when the signals are weak or intermittent, you can activate the Local (LOC)
mode by pressing the LO/DX button (9) (“LOCAL” appears on the display) on the control panel
(or the LOC button on the remote control). This mode favors access to local stations whose
signals are much stronger; thereby improving radio reception. Press the LOC button again to
terminate Local receive mode.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Hold a preset button (12-17) for three seconds.
The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (12-17) to select the corresponding stored
station.
Automatically Store / Preset Scan (AS/PS, AMS)
Automatically Store
Select a band (if needed). Press AS/PS (11) on the control panel (or the AMS button on the
remote control) for more than three seconds to automatically select six str
ong stations and
store them in the current band. The new stations replace any stations already stored in that
band.
Preset Scan
Select a band (if needed). Press AS/PS (11) to scan stations stored in the current band. The
unit will pause for ten seconds at each preset station. Press AS/PS again to stop scanning
when the desired station is reached.
Loudness Control (B, BND)
Press the B button (19) on the control panel (or the BND button on the remote control) to turn
the “Loudness” function on/off. When Loudness is activated, the display will show “X-Bas” for a
few seconds.
Preset Equalizer (PEQ)
Press the PEQ button (7) to select from the following preset equalizer functions: FLAT >
CLASSIC > POP M > ROCK > DSP OFF. When “DSP OFF” is selected, the EQ function is
controlled by the Bass/Treble settings.
Stereo
The unit will automatically pick up an FM stereo signal, when available. When in stereo mode,
the “ST” icon appears in the display. When no stereo signal is available, the unit will
automatically revert to mono operation, and no icon will be displayed. To manually switch
between mono and stereo mode, press the MO button (23) on the remote control.
JCD3006
1
2
3
5
6
7
89
10
11
20
21 12
13
14
15 16
17
18
19
4 22
Best
Reception
Worst
Reception