Filter
Top Products
TROUBLESHOOTING
25
PROBLEM
IR remote inoperative
Disc won't play
No sound or distorted sound
Play starts, but then stops immediately
Can’t advance through a movie
— Verify that the batteries in the remote are fresh.
— Verify that the remote sensor eye is not obstructed.
— Verify that the correct mode (M1 or M2) has been selected.
— Insert a disc with the label side facing up.
— Check the type of disc you put into disc tray. This DVD only plays DVDs, audio CDs
and MP3s.
— Both the unit and the disc are coded by region. If the regional codes don’t match,
the disc can’t be played. This DVD player is set to Region Number 1.
— Make sure your DVD is connected properly. Make sure all cables are securely
inserted into the appropriate jacks.
— If you are using the 2-channel IR headphones, make sure you turn on the IR
headphone power, and make sure the correct channel (A-B) is selected.
— Make sure the Modulator is ON and the proper Frequency has been selected.
— Make sure that unit is set to M1 when using Single Channel Headphones.
— The disc is dirty. Clean it.
— Condensation has formed. Allow player to dry out.
— You can’t advance through the opening credits and warning information that
appears at the beginning of movies because the disc is programmed to prohibit that
action.
SOLUTION