Filter
Top Products
MP6212
7
OPERATION
Power
Press the power button (2) to turn the unit on. Press and hold the power
button again to turn the unit off.
NOTE: LCD panels may take longer to respond when subjected to cold
temperatures for an extended period of time. In addition, the visibility
of the numbers on the LCD may decrease slightly. The LCD display
will return to normal when the temperature increases to a normal
range.
Source
Press the SRC button (6) to select a different mode of operation, as
indicated on the display panel. Available modes include tuner (FM1, FM2,
FM3, AM1, AM2), CD, auxiliary (AUX) and SAT. CD mode appears in the
menu only if a CD is present in the CD player. SAT appears only when a
satellite module is installed.
Audio Mute
Press the mute button (2) to silence the audio volume. “Mute” appears on
the display. Press mute again to restore volume to the previous setting.
Volume / Audio Control
To increase the volume, turn the rotary encoder (5) clockwise. To decrease
the volume, turn the rotary encoder counter-clockwise. When volume is
adjusted, the volume level will be shown on the display panel as a number
ranging from “0” (lowest) to “46” (highest).
Press the MENU button (5) repeatedly to step through the following audio
functions: bass (BAS), treble (TRE), balance (BAL), fader (FAD) and
volume (VOL). The unit automatically exits audio control mode after five
seconds of inactivity.
Bass
To adjust the bass level from “-6” to “+6”, press the MENU button (5) until
“BAS” appears in the display. Turn the rotary encoder clockwise to increase
or counter-clockwise to decrease the bass. “0” represents a flat response.
Treble
To adjust the treble level from “-6” to “+6”, press the MENU button until
“TRE” appears in the display. Turn the rotary encoder clockwise to increase
or counter-clockwise to decrease the treble. “0” represents a flat response.
Balance
To adjust the balance from “12L” (full left) to ”12R” (full right), press the
MENU button until “BAL” appears in the display. Turn the rotary encoder to
adjust the balance between the left and right speakers. “L = R” represents a
center balance.
Fader
To adjust the fader from “12F” (full front) to “12R” (full rear), press the
MENU button until “FAD” appears in the display. Turn the rotary encoder to
adjust the fader between the front and rear speakers. “F = R” represents a
center fader level.
VOL
VOL
BAS
TRE
BAL
FAD
P
U
S
H
S
E
E
L
C
T
B
B
S
L
E
T
A
A
A
D
F
R
P
U
S
H
S
E
E
L
C
T
B
B
S
L
E
T
A
A
A
D
F
R
P
U
S
H
S
E
E
L
C
T
B
B
S
L
E
T
A
A
A
D
F
R
P
U
S
H
S
E
E
L
C
T
B
B
S
L
E
T
A
A
A
D
F
R
MP6212
MOSFETPOWERED
PTY
SCAN
AS
20
21
DN
UP
/
CH/CAT
SAT
READY