JL Audio C2-350x Car Speaker User Manual


  Open as PDF
of 8
 
2 | JL Audio - C2-350x Owner’s Manual
3
C2-350x SPECIFICATIONS:
Woofer: Injection-molded, Mica-filled,
Polypropylene Cone, Polyether Foam Surround
0.75 in. Voice Coil on Kapton® Former, Symmetrical Roll Spider
Ferrite Magnet
Tweeter: 0.75 in. (19 mm) Silk Dome, Ferrofluid Cooling /
Damping Neodymium Magnet
Crossover: Natural Roll-Off Low-Pass, 1st Order High-Pass
Filter with Electrolytic Capacitor
Continuous Power Handling: 25 Watts
Recommended Amp Power: 10-40 Watts per channel (RMS)
Efficiency: 83.0 dB @ 1W/1m | 89.0 dB @ 1W/0.5m
Sensitivity: 86.0 dB @ 2.83V/1m
Nominal Impedance: 4 ohm
Frequency Response: 130 Hz - 22 KHz ± 3 dB
Included Components and Parts:
• Two C2-350x 3.5-inch (90mm) Coaxial loudspeakers
• Four #8 x 1 inch (25mm) sheet metal screws
• Four Mounting Clips
• Two 5.2 mm female crimpable connectors
• Two 2.8 mm female crimpable connectors
GETTING STARTED
•Turnofftheaudiosystem.Itisalso
advisabletodisconnectthenegative(–)
terminalofyourvehicle’sbatterywhenever
performinginstallationwork.
•Beforecutting,drillingorinsertinganyscrew,
checkclearancesonbothsidesoftheplanned
mountingsurface.Alsocheckforanypotential
obstacles,suchaswindowtracksandmotors,
wiringharnesses,etc.Checkbothsidesofthe
vehicle,manyvehiclesarenotsymmetrical!
•Alwayswearprotectiveeyewear.
SPEAKER PLACEMENT CONSIDERATIONS
Inmostcases,yourspeakerswillbeplacedinto
factoryspeakerlocations.Ifyouhavesomespeaker
mountingflexibility,keepthefollowinginmind:
Lowermountinglocations,suchasthelowerfront
cornerofadoororakick-panelprovidethegreatest
pathlengthdistancesforthesoundemittedbythe
speakers.Forthisreason,theyaregenerallymore
desirablethanhighermountinglocations.Higher
mountinglocationswillusuallyresultinextreme
near-sidesoundstagebiaswhichcompromisesthe
stereolisteningexperience.
 previous next