JL Audio SB-B-5SER/12W6v2 Car Speaker User Manual


  Open as PDF
of 3
 
Continued on Next Page
SB-B-5SER/12W6v2_INSTR_SKU#011233
SB-B-5SER/12W6v2_INSTR_SKU#011233
STEP 7
Remove the 9 o’clock and 3 o’clock position mounting
screws from the woofer. Replace these mounting screws
with the supplied threaded rods.
Remove all the mounting screws, woofer and fill from the
Stealthbox®.
STEP 6
Place the supplied spacer onto the set screw stud.
STEP 5
Place the rear factory clip back into place.
Thread the supplied set screw stud into the weld nut,
leave 1 1/2-inch exposed.
STEP 4
Place the side panel back into the trunk.
Page 2 • JL Audio, Inc 2007
STEP 9
Position the Stealthbox into position.
Carefully guide the threaded stud through the hole on the
back side of the Stealthbox®.
STEP 11
Place the fill back into the Stealthbox®.
STEP 10
From inside the Stealthbox®, place the supplied washer, lock
wash and then nut onto the set screw stud.
Using a 9/16-inch deep socket, secure tightly.
Do not over tighten.
STEP 8
Attach the speaker wire to the terminal on the Stealthbox®.
 previous