Filter
Top Products
SB-B-5SER/12W6v2_INSTR_SKU#011233
SB-B-5SER/12W6v2_INSTR_SKU#011233
CONGRATULATIONS
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
STEP 22
Remove the two threaded rods, a pair of pliers help with this
removal.
Finish securing the woofer with the last two mounting
screws.
STEP 21
Using the threaded rods as guide, place the woofer back
onto the Stealthbox® and mount.
STEP 20
Attach the proper speaker wires to the woofer’s terminal.
Page 3 • JL Audio, Inc 2007
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011233 -05-01-200
JLA-SKU#011233 -05-01-200
7
7 • Printed in USA • ©2007 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
patents pending. For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
www.jlaudio.com
10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA
INCLUDED HARDWARE
(1)
(1)
7/8-inch(L) x 3/4-inch(OD) x 3/8-inch(ID) Spacer
7/8-inch(L) x 3/4-inch(OD) x 3/8-inch(ID) Spacer
(1)
(1)
3/8-inch -16 x 3” Set Screw Stud
3/8-inch -16 x 3” Set Screw Stud
(1)
(1)
3/8-inch -16 x 5/8-inch Weld Nut
3/8-inch -16 x 5/8-inch Weld Nut
(1)
(1)
3/8-inch -16 Hex Nut
3/8-inch -16 Hex Nut
(1)
(1)
3/8-inch Spilt Lock Washer
3/8-inch Spilt Lock Washer
(3)
(3)
Button Head Rivet
Button Head Rivet
(1)
(1)
3/8-inch Flat Washer
3/8-inch Flat Washer
SPECIFICATIONS
Enclosure Type:
Acoustic Suspension (sealed)
Acoustic Suspension (sealed)
Driver Type:
12W6v2-D4
12W6v2- D4
Nominal Impedance:
2 ohms mono
2 ohms mono
Continuous Power Handling:
400 Watts
400 Watts
P O W E R R E C O M M E N D A T I O N
POWER RECOMMENDATION
JL Audio recommends using a high quality amplifier such as the JL Audio 500/1v2.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1v2
when being used to power your Stealthbox
®
.
+12VDC RemoteGround
JL AUDIO 500/1
five-channel system amplifier
+
_
_
+
Subwoofer Output
MONO OUTPUT ONLY
40
45
55
65
85
120
200
Filter Freq. (Hz)
Mode / Slope
Off / 12dB / 24dB
Amp LP Filter
Infrasonic Freq. (Hz)
15
18
25
30
40
50
60
Off / 30Hz
Infrasonic Filter
0.5
0.7
1.1
1.6
2.7
4.3
"Q"
20
25
35
45
55
70
85
Center Freq.
0
+4
+10
+13
+15
Boost (dB)
Off / On
Bass EQ
Remote Bass Port
Advanced
Bass
Control
Preamp Output Section
Full Range / Amp Filter / Out Filter
Output Mode
Filter Slope
12dB / 24dB
40
45
55
65
85
120
200
Filter Freq. (Hz)
Left Ch. Right Ch.
Filter Mode
LP / HP
Amplifier Input Section
Input Sens.
Left Ch.
Right Ch.
Signal Sensing
Off / On
Input Voltage
Low / High
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location:
4.0-inch / Front Doors
4.0-inch / Front Doors
Fits JL Audio Models:
TR400-CXi
TR400-CXi
Rear Speaker Size / Location:
4.0-inch / Rear Door
4.0-inch / Rear Door
Fits JL Audio Models:
TR400-CXi
TR400-CXi