Filter
Top Products
SB-D-MGACAB/10W6v2_INSTR_SKU# 011217
SB-D-MGACAB/10W6v2_INSTR_SKU# 011217
CONGRATULATIONS
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
STEP 14
Use scissors to clean up the carpet’s edge.
Mount the folding floor extensions.
STEP 13
The passenger’s side folding floor extension will only need to
be cut on the rear corner, driver’s side.
If the folding floor extensions are to be retained, they will
need to be permanently modified, follow STEPS 12-14.
If they are not to be retained,
CONGRATULATIONS
You have completed the installation for this model!
STEP 12
The driver's side folding floor extension will need to be cut
across the entire rear section. As in the picture, use the metal
framing as a cutting guide.
Page 3 • JL Audio, Inc 2006
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011217-9-52006 • Printed in USA • ©2005 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479
#6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending.
For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
www.jlaudio.com
10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA
INCLUDED HARDWARE
(2)
(2)
3/8-inch - 16 x 2-1/2-inch Socket Cup Screw
3/8-inch - 16 x 2-1/2-inch Socket Cup Screw
(2)
(2)
3/8-inch Hex Nut
3/8-inch Hex Nut
(2)
(2)
3/8-inch x 2-inch Fender Washer
3/8-inch x 2-inch Fender Washer
(2)
(2)
3/8-inch USS Flat Washer
3/8-inch USS Flat Washer
(2)
(2)
3/8-inch Split Lock Washer
3/8-inch Split Lock Washer
SPECIFICATIONS
Enclosure Type:
Acoustic Suspension (sealed)
Acoustic Suspension (sealed)
Driver Type: Two
10W6v2-D4
10W6v2-D4
Nominal Impedance:
4 ohms mono
4 ohms mono
Continuous Power Handling:
800 Watts
800 Watts
POWER RECOMMENDATION
JL Audio recommends using a high quality amplifier such as the JL Audio 1000/1.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 1000/1 when
being used to power your Stealthbox
®
.
+12VDC RemoteGround
JL AUDIO 1000/1
monoblock subwoofer amplifier
+
_
_
+
Subwoofer Output
MONO OUTPUT ONLY
Amplifier Input Section
Left Ch.
Input Voltage Input Sens.
Low / High
Right Ch.
40
45
55
65
85
120
200
Filter Freq. (Hz)
Mode / Slope
Off / 12dB / 24dB
Amp LP Filter
Infrasonic Freq. (Hz)
15
18
25
30
40
50
60
Off / On
Infrasonic Filter
0.5
0.7
1.1
1.6
2.7
4.3 20
25
35
45
55
70
85 0
+4
+10
+13
+15
"Q" Center Freq. Boost (dB)
Off / On
Bass EQ
Remote Bass Port
Advanced
Bass
Control
Preamp Output Section
Full Range / Amp Filter / Out Filter
Output Mode
Filter Slope
12dB / 24dB
Filter Freq. (Hz)
Left Ch. Right Ch.
Filter Mode
LP / HP
40
45
55
65
85
120
200
Output Polaity
Normal / Reversed
The JL Audio 1000/1 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location:
6 x 9 / Front Doors
6 x 9 / Front Doors
Fits JL Audio Models:
N/A
N/A
Rear Speaker Size / Location:
5.25-inch / Rear Door
5.25-inch / Rear Door
Fits JL Audio Models:
TR525-CXi, VR525-CXi & XR525-CXi
TR525-CXi, VR525-CXi & XR525-CXi
1-1/2-inches
3-inches