Filter
Top Products
Continued on Next Page
SB-J-GCHER3/10W1v2_INSTR_SKU#011235
SB-J-GCHER3/10W1v2_INSTR_SKU#011235
STEP 7
With a small flat head screw driver, pop off the small cover
that is located on the top half of the c-pillar.
With Phillips head screw driver, remove the screw that has
been exposed.
Remove this top half of the c-pillar.
STEP 6
Remove the flooring from the vehicle.
STEP 5
Remove the false floor.
Remove the two mounting bolts that secure the flooring to
the vehicle.
STEP 4
Remove the tailgate’s bottom sill plate.
Page 2 • JL Audio, Inc 2007
STEP 9
With a Phillips head screw driver, remove the screw from the
rear section of the plastic panel.
STEP 11
Remove the tailgate’s upper sill plate.
STEP 10
With an hex key, remove the screw and D-ring from the rear
section of the plastic panel.
STEP 8
With a Phillips head screw driver, remove the screw from the
front section of the plastic side panel.