Filter
Top Products
➔➔
➔➔➔
STEP 10: Lift at the rear of the console and care-
fully pull unit over the emergency hand brake arm.
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 7: Disconnect the white wiring plug at the
rear of the A/C controls.
STEP 11: Disconnect the wiring harness at the
plug located under the center console.
➔
STEP 12: Carefully guide the shifter boot trim
panel through the front opening in the console.This
will allow for full removal of the center console.
*Careful not to damage the shifter boot or
scratch the dash panel. *
STEP 13: Remove the center console, out of the
vehcile.
STEP 8: With the shifter trim panel moved to
one side. Remove the pair of Philip head screws at
the front edge of the console.
STEP 9: Engage the emergency brake, by pulling
up on the handle.
SB-N-350/10W3v2, JL AUDIO, Inc 2004
Sheet SKU#011187 Revision 2/11/2004Page 2
www.jlaudio.com
STEP 14: Remove the rear bulkhead front panel,
by carefully pulling towards the front of the vehcile
around the glove box.