JL Audio SB-N-350/10W3v3 Car Speaker User Manual


 
➔➔
➔➔
STEP 18: Pull back the carpet in the front section
of the cargo area to reveal the metal floor.
Remove the child seat anchor hooks, reinstall factory
bolts without hook.
Locate the existing holes(behind the driver’s side
and passenger’s side seat), to be used to mount the
Stealthbox. Identified by the white circle.
Cont.
From
Previous
Page
Continued on Next Page
STEP 16: Remove the pair of 10mm head bolts at
the rear of the glove box.
STEP 19: Cut the carpet to create a flap that can
be folded to allow access to the mounting holes.
STEP 20: If the vehicle is so equipped, fold back
floor mat as shown to access the mounting bolts.
STEP 22: At this time, attach the speaker wire
from the amp to the Stealthbox’s terminal.
*Check for proper operation of the
woofers.*
STEP 17: Remove the numerous 10mm head
bolts securing the front edge of the glove box liner.
SB-N-350/10W3v2, JL AUDIO, Inc 2004
Sheet SKU#011187 Revision 2/11/2004 Page 3
www.jlaudio.com
STEP 15:
Remove the pair of Philip head
screws securing the passenger side glove box’s
door latch.
Repeat this STEP for the driver’s side, if
equipped with the glove box. Remove the fac-
tory woofer on the driver’s side, if equipped.
STEP 21: Thread in the supplied pair of socket
cup set screws. Leaving about 1.5” exposed.