Filter
Top Products
➔
➔
STEP 13(B): You can use different cutting tools.
Here we used a cutting wheel.
STEP 15: Back inside the SUV, Look into the area that the Stealthbox is going to
reside.There is a metal lip to the left. On this lip there is an exposed hole. Measure 3/4”
from the middle of this hole down and mark.
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 14: Use a sanding wheel or just sand paper
to clean off the edge off the cut.
STEP 16: There is a metal lip to the right. On this lip there is also an exposed hole.
Measure 1-1/4” from the middle of this hole downward and mark.
SB-N-ARMDA/10W6v2, JL AUDIO, Inc 2005
Sheet SKU#011193 Revision 5/26/2005Page 3
www.jlaudio.com
STEP 13(C)
➔
STEP 17: *CAUTION*
Before drilling, make sure that you are not going to
be drilling into any electrical wiring or anything else
that might cause a reduction in your weekly pay.
Always wear eye protection when drilling.
With the use of a 1/2” drill bit and drill. Drill at the
marks from STEPs 14 & 15.
➔
3/4”
1-1/4”