Filter
Top Products
➔➔
➔➔➔
➔
STEP 7:
Insert supplied Socket Set Cup
Screw into the enclosure so the rod extends
approximately 1/4” out of the enclosure.
STEP 11:
Adjust the Socket Cup Set Screw,
so that is extends 1 1/2” out of the enclosure.
Cont.
From
Page 1
Continued on Page 3 ➔
➔
STEP 8:
Roll the floor carpet back to expose
the metal floor in the location shown above.
Place the supplied wax square on the metal
floor as shown above.
STEP 12:
Insert the supplied U-bolt in
factory hole.
(located at the top of the enclosure location
as shown above)
➔
STEP 13:
Run speaker wires to the location
of the Stealthbox. Check the Stealthbox for
proper operation.
STEP14:
Using the supplied 1/4”washer, 1/4”
lock washer and 1/4”x1”bolt. Mount the L-
bracker to top of the enclosure.The bottom
of the L-brackt needs to point towards the
driver’s side fender.
STEP 15:
Place the Stealthbox in its proper
location, making sure to place the threaded
rod into the previously drilled hole in the
floor.
STEP16:
Place the supplied 1/4’lock washer,
1/4” flat washer in that order onto the
1/4”x1” bolt. Pass the bolt through the
mounted L-bracker and thread into the U-
bolt installed in
STEP 12
. Do not fully tighten.
STEP 9:
Place the Stealthbox into place so as
to allow the Socket Set Cup Screw to make
an impression in the wax square.
STEP 10:
Using a 1/2” drill bit, drill a hole
through the metal floor in the location of the
impression in the wax square.
SB-T-SEQ/10W3v2-D2, JL AUDIO, Inc 2002
Sheet SKU#011111 Revision 10/30/02Page 2
www.jlaudio.com
➔