Filter
Top Products
Continued on Next Page
SB-VW-GTI/10W6v2_INSTR_SKU#011250
SB-VW-GTI/10W6v2_INSTR_SKU#011250
STEP 5
Note: Before drilling, you are drilling into the rear
fender well. Once you protrude to the outside, do not
go any further or you will be paying for a new rear
tire. Always wear eye protection when drilling!
With a drill and a 1/2-inch drill bit, drill through the
impression made in the wax square.
Remove the wax square.
STEP 4B
The Stealthbox® will be raised off the floor. This is to allow
the factory flooring to be pulled from the cargo area, once
the Stealthbox® is installed.
STEP 4A
The Stealthbox® needs to fit all the way to top plastic panel.
*Read the next three steps to fully understand
this procedure.*
STEP 4
Place the Stealthbox® into the mounting location and press
firmly onto the Stealthbox®.
Page 2 • JL Audio, Inc 2007
STEP 7
Place the Stealthbox® into the mounting location. Guide the
socket cup set screw through the drilled hole.
STEP 9
Behind the strut, pull the black plastic guard to gain access to
the protruding socket cup set screw.
STEP 8
Jack up the driver’s side rear of the vehicle.
You should be able to access the socket cup set screw with
the rear wheel on the car. If necessary, you may remove the
wheel off the car.
STEP 6
Run speaker wire from the amplifier’s location to the
Stealthbox
®
location and check for proper operation of
the woofer.