Filter
Top Products
SB-VW-GTI/10W6v2_INSTR_SKU#011250
SB-VW-GTI/10W6v2_INSTR_SKU#011250
CONGRATULATIONS
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
STEP 10
Place a supplied fender washer, flat washer, split
lock washer
lock washer
and hex nut onto the socket cup set screw. Secure, but do
not over tighten. We know you are “Strong like bull”, but you
do not have to use all your He-man power on this little nut.
Note: For added protection it is recommended that
you apply a bead of silicone between the vehicle and
the fender washer. After the bolt assembly is tightly
secured, it is also recommended that vehicle under-
coating material is applied to the exposed assembly
Page 3 • JL Audio, Inc 2007
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011250 -11-1-200
JLA-SKU#011250 -11-1-200
7
7 • Printed in USA • ©2007 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479
#6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending.
For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
www.jlaudio.com
10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA
INCLUDED HARDWARE
(1)
(1)
3/8-inch -16 x 2 1/2-inch Socket Cup Set Screw
3/8-inch -16 x 2 1/2-inch Socket Cup Set Screw
(1)
(1)
3/8inch -16 Hex Nut
3/8inch -16 Hex Nut
(1)
(1)
3/8-inch Fender Washer
3/8-inch Fender Washer
(1)
(1)
3/8-inch Flat Washer
3/8-inch Flat Washer
(1)
(1)
3/8-inch Split Lock Washer
3/8-inch Split Lock Washer
SPECIFICATIONS
Enclosure Type:
Acoustic Suspension (sealed)
Acoustic Suspension (sealed)
Driver Type:
10W6v2-D4
10W6v2-D4
Nominal Impedance:
2 ohms mono
2 ohms mono
Continuous Power Handling:
400 Watts
400 Watts
P O W E R R E C O M M E N D A T I O N
POWER RECOMMENDATION
JL Audio recommends using a high quality amplifier such as the JL Audio A1400.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the A1400 when
being used to power your Stealthbox
®
.
Bass Boost Controls
Input Voltage
Low
|
High
CH 1 (Left)
Input Sens. LP Filter
Filter Freq. (Hz)
40
45
55
65
80
100
200
Bass Boost
Remote
Bass Port
Power Protect
CH 2 (Right)
Pre-Outs
The JL Audio A1400 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location:
6.5-inch / Front Doors
6.5-inch / Front Doors
Fits JL Audio Models:
TR650-CSi, TR650-CXi, VR650-CSi, VR650-CXi, C5650, C5-650x & ZR650-CS
TR650-CSi, TR650-CXi, VR650-CSi, VR650-CXi, C5650, C5-650x & ZR650-CS
i
i
Rear Speaker Size / Location:
6.5-inch / Rear Doors / Side Panels
6.5-inch / Rear Doors / Side Panels
Fits JL Audio Models:
TR650-CXi, VR650-CXi, XR650-CXi & C5-650x
TR650-CXi, VR650-CXi, XR650-CXi & C5-650x