Filter
Top Products
2
A
Typical connections
ELECTRICAL CONNECTIONS
Rear line out (see diagram )
Rear ground terminal
15 A fuse
Black
Blue with white stripe
Red
Yellow
*
2
To the metallic body or chassis of the car
Ignition switch
Fuse block
To an accessory terminal in the fuse block
To the remote lead of other equipment (200 mA max.)
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
Antenna terminal
Blue
To the automatic antenna if any (250 mA max.)
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1 Connect the colored leads of the power cord in the order specified in the illustration below.
2 Connect the antenna cord.
3 Finally connect the wiring harness to the unit.
*
1
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise the power cannot be turned on.
*
3
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
Connecting the external amplifier or subwoofer
B
You can connect an amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
or
PurplePurple with black stripeGreenGreen with black stripeGrayGray with black stripeWhiteWhite with black stripe
Right speaker (rear)Left speaker (rear)Right speaker (front)Left speaker (front)
Y-connector
*
1
Remote lead
Subwoofer
Rear speakers
JVC Amplifier
JVC Amplifier
Set “L/O MODE” to “SUB.W” (See page 15 of the
INSTRUCTIONS.)
Set “L/O MODE” to “REAR” (See page 15 of the
INSTRUCTIONS.)
Front speakers
Signal cord
*
1
Remote lead (blue with white stripe)
To the remote lead of other equipment or
automatic antenna if any
Remote lead
Install1-2_KD-R504[UI]_2.indd 2Install1-2_KD-R504[UI]_2.indd 2 22/10/08 1:58:56 PM22/10/08 1:58:56 PM