49
ENGLISH
Maintenance
Warped
disc
Disc
Stick-on
label
Sticker
Sticker
residue
Do not use the following discs:
To keep discs clean
A dirty disc may not play correctly.
If a disc does become dirty, wipe
it with a soft cloth in a straight line
from center to edge.
• Do not use any solvent (for example,
conventional record cleaner, spray, thinner,
benzine, etc.) to clean discs.
To play new discs
New discs may have some rough
spots around the inner and outer
edges. If such a disc is used, this
receiver may reject the disc.
To remove these rough spots, rub the edges
with a pencil or ball-point pen, etc.
How to handle SD card
SD cards are precision products. DO NOT
impact, bend, drop, or wet them.
Available character
In addition to the Roman alphabets (A – Z,
a – z), the following characters will be used.
• You can also use the following characters
to assign titles (see page 41).
Accented letters: upper case
Accented letters: lower case
Numbers and symbols
How to clean the connectors
Frequent detachment will deteriorate the
connectors.
To minimize this possibility, periodically wipe
the connectors with a cotton swab or cloth
moistened with alcohol, being careful not to
damage the connectors.
Connector
Moisture condensation
Moisture may condense on the lens inside the
CD player in the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the CD player may
malfunction. In this case, eject the disc and
leave the receiver turned on for a few hours
until the moisture evaporates.
How to handle discs
When removing a disc from
its case, press down the center
holder of the case and lift the
disc out, holding it by the
edges.
• Always hold the disc by the edges. Do not
touch its recording surface.
When storing a disc into its case, gently insert
the disc around the center holder (with the
printed surface facing up).
• Make sure to store discs into the cases after
use.
Center holder
EN49-53_KD-AR8500[J]f.indd 49EN49-53_KD-AR8500[J]f.indd 49 05.4.8 2:39:48 PM05.4.8 2:39:48 PM