JVC KD-G200 Car Stereo System User Manual


 
6
ENGLISH
3. Return the battery holder.
Insert again the battery holder by pushing it
until you hear a clicking sound.
WARNING:
Store the battery in a place which children
cannot reach.
If a child accidentally swallows the battery,
immediately consult a doctor.
Do not recharge, short, disassemble or heat the
battery or dispose of in a fire.
Doing any of these things may cause the battery
to give off heat, crack or start a fire.
Do not leave the battery with other metallic
materials.
Doing this may cause the battery to give off
heat, crack or start a fire.
When throwing away or saving the battery,
wrap in tape and insulate; otherwise, it may
cause the battery to give off heat, crack or start
a fire.
Do not poke the battery with tweezers or similar
tools.
Doing this may cause the battery to give off
heat, crack or start a fire.
CAUTION:
DO NOT leave the remote controller in a place
(such as dashboards) exposed to direct sunlight
for a long time. Otherwise, it may be damaged.
Preparing the remote
controller
This section is only for KD-AR200.
Before using the remote controller:
Aim the remote controller directly at the remote
sensor on the main unit. Make sure there is no
obstacle in between.
Do not expose the remote sensor to strong
light (direct sunlight or artificial lighting).
Installing the battery
When the controllable range or effectiveness
of the remote controller decreases, replace
the battery.
1. Remove the battery holder.
1) Push out the battery holder in the
direction indicated by the arrow using a
ball point pen or a similar tool.
2) Remove the battery holder.
2. Place the battery.
Slide the battery into the holder with the
+ side facing upwards so that the battery
is fixed in the holder.
Lithium coin
battery (product
number: CR2025)
(back side)
(back side)
Remote sensor
EN04-06KD-AR200[J]f.p65 9/26/03, 7:53 PM6