Filter
Top Products
16
ENGLISH
You can connect an external component to the
AUX (auxiliary) input jack on the control panel.
~
• You can also select “AUX IN” as the playback
source by pressing the SRC (source) button.
Ÿ Turn on the connected component and
start playing the source.
! Adjust the volume.
⁄ Adjust the sound as you want. (See
page 13.)
To check the other information while
listening to an external component
Other external component operations
Indications Item
( : Initial)
Selectable settings, [reference page]
SUB.W FREQ *
6
Subwoofer cutoff
frequency
• LOW
• MID
• HIGH
: Frequencies lower than 90 Hz are sent to the subwoofer.
: Frequencies lower than 135 Hz are sent to the subwoofer.
: Frequencies lower than 180 Hz are sent to the subwoofer.
TAG DISPLAY
Tag display
• TAG ON
• TAG OFF
: Shows the Tag information while playing MP3/WMA tracks, [12].
: Cancels.
AMP GAIN
Amplifier gain control
• LOW POWER
• HIGH POWER
: VOLUME 00 – VOLUME 30 (Select this if the maximum power of the
speaker is less than 50 W to avoid them from damaging the speaker.)
: VOLUME 00 – VOLUME 50
IF BAND
Intermediate
frequency band
• AUTO
• WIDE
: Increases the tuner selectivity to reduce interference noise between
close stations. (The stereo effect may be lost.)
: Subject to the interference noise from adjacent stations, but the
sound quality will not be degraded and the stereo effect will remain.
*
6
For KD-G441: Displayed only when “L/O MODE” is set to “SUB.W.”
AUX IN Ô Clock
3.5 mm stereo mini
plug (not supplied)
Portable audio player, etc
EN08-17_KD-G441_003A_4.indd 16EN08-17_KD-G441_003A_4.indd 16 10/24/07 10:04:18 AM10/24/07 10:04:18 AM