Filter
Top Products
18 ENGLISH
Menu item
Selectable setting, [Initial: Underlined]
AUDIO
FADER *
3,
*
4
R06 — F06
[
00
]
:
Adjusts the front and rear speaker output balance.
BALANCE *
4
L06 — R06
[
00
]
:
Adjusts the left and right speaker output balance.
LOUD ON
:
Boost low and high frequencies to produce a well-balanced sound at a low volume
level. /
OFF
:
Cancels.
VOL ADJUST –05 — +05
[
00
]
:
Presets the volume adjustment level of each source (except
“FM”), compared to the FM volume level. The volume level will automatically increase or
decrease when you change the source. Before adjustment, select the source you want to
adjust. (“VOL ADJ FIX” appears on the display if “FM” is selected as the source.)
SUB.W ON
:
Turns on the subwoofer output. /
OFF
:
Cancels.
SUB.W LPF LOW 55Hz
/
LOW 85Hz
/
LOW 120Hz
:
Frequencies lower than
55 Hz/85 Hz/120 Hz are sent to the subwoofer.
SUB.W LEVEL 00 — 08
[
04
]
:
Adjusts the subwoofer output level.
HPF ON
:
Activates the High Pass Filter. Low frequency signals are cut off from the front/rear
speakers. /
OFF
:
Deactivates (all signals are sent to the front/rear speakers).
BEEP ON
/
OFF
:
Activates or deactivates the keypress tone.
TEL MUTING *
5
ON
:
Mutes the sounds while using the cellular phone (not connected through
KS-BTA100). /
OFF
:
Cancels.
AMP GAIN *
6
LOW POWER
:
VOLUME 00 – VOLUME 30 (Selects if the maximum power
of each speaker is less than 50 W to prevent damaging the speakers.) /
HIGH POWER
: VOLUME 00 – VOLUME 50
TUNER
SSM *
7
For settings, see page 8.
AREA US
:
When using in North/Central/South America. AM/FM intervals are set to
10 kHz/200 kHz. /
EU
:
When using in any other areas. AM/FM intervals are set to
9 kHz/50 kHz. /
SA
:
When using in South American countries where FM interval is
50 kHz. AM interval is set to 10 kHz.
MONO *
7
For settings, see page 8.
BLEND HOLD *
7
For settings, see page 8.
IF BAND AUTO
:
Increases the tuner selectivity to reduce interference noises between adjacent
stations. (Stereo effect may be lost.) /
WIDE
:
Subject to interference noises from
adjacent stations, but sound quality will not be degraded and the stereo effect will
remain.
TAG ALL CLEAR
For settings, see page 10.
*
3
If you are using a two-speaker system, set the fader level to “00.”
*
4
This adjustment will not affect the subwoofer output.
*
5
This setting does not work if <BT ADAPTER> is selected for <R-AUX> of the <SRC SELECT>.
*
6
The volume level automatically changes to “VOLUME 30” if you change to <LOW POWER> with the volume
level set higher than “VOLUME 30.”
*
7
Displayed only when the source is “FM” or “AM.”
EN02-23_KD-AHD79[J]3.indd 18EN02-23_KD-AHD79[J]3.indd 18 11/22/10 3:11:53 PM11/22/10 3:11:53 PM