Filter
Top Products
35
ENGLISH
Changing the source
• If you change the source, playback also stops.
Next time you select the same source again,
playback starts from where it has been
stopped previously.
Ejecting a disc
• If the ejected disc is not removed within
15 seconds, the disc is automatically inserted
again into the loading slot to protect it from
dust. (Disc will not play this time.)
Sound adjustments
Selecting the DSP modes—DSP
• Effectiveness of “V.Cancel” depends on the
recording condition of the sources:
– Monaural sources such as AM and
monaural FM broadcasting programs.
– Multiplex sound sources.
– Sources recorded with duets, strong echo, a
chorus, or only a few instruments.
• When “4ch” is selected, rear speakers are
used only to reproduce reflections and
reverberations in order to create a being-there
feeling in your car compartment.
• If fader or balance has been set close to
its extreme, appropriate effect may not be
obtained.
• You cannot adjust the effect level and speaker
number when “Defeat” is selected with
crossover network activated.
Storing your own sound modes
• If you do not want to store your current
adjustment, but only to apply the adjustment
to the current playback source, press MENU
to go back to the operation screen of the
current source. Adjustment you made
remains effective until you select a sound
mode.
Setting the sound modes—SEL
• If you are using a two-speaker system, set the
fader level to the center.
• Subwoofer out setting takes effect only when a
subwoofer is connected.
• You cannot change the input level—
“VolAdjust” of the FM stations. If the source
is FM, “Fix” will appear when you try to
adjust it.
General settings — PSM
• “Auto Dimmer” may not work correctly on
some vehicles, particularly on those having a
control dial for dimming. In this case, change
the “Dimmer” setting to any one other than
“Auto.”
• If you change the “Amp Gain” setting from
“High PWR” to “Low PWR” while the volume
level is set higher than “Volume 30,” the unit
automatically changes the volume level to
“Volume 30.”
EN24-35_SH1000J_001A_2.indd 35EN24-35_SH1000J_001A_2.indd 35 1/17/06 10:46:37 AM1/17/06 10:46:37 AM