Filter
Top Products
11
ENGLISH
Storing channels in memory (Auto memory)
The auto memory function picks up the TV broadcast signals in the area where you are and
stores them automatically in memory.
1
Select TV as the input source.
Press the MODE button on the monitor or the remote
controller repeatedly to select TV.
2
Start scanning TV broadcast signals.
Press and hold the AUTO/MANU button on the monitor or
press the A.MEMO button on the remote controller.
The auto memory function starts and TV broadcast signals
are picked up and stored in memory while scanning.
When scanning is over, the screen shows the TV program of the smallest channel number in
memory.
Notes:
• TV stations with weak signals are not be picked up, therefore not being stored in memory.
• If you drive from one broadcasting area to another, the stored channels will not be tuned in. In this
case, perform the auto memory function again to store the stations in another area.
Monitor Remote
Monitor Remote
MODE
CH
CH
H/P
VOL
H/P
VOL
MODE
AUTO/MANU
VIDEO 1
TV
VIDEO 2
DOWN UP
AUTO/MANU
MODE POWER
KV-M700 color monitor
CH
CH
COLOR
BRIGHT
CONTRA
H/P
VOL
H/P
VOL
MODE
SKIP
A.MEMO CALL
V
O
C
A
L
RF
MONI
VCR
KV-M700 remote
controller
1
2
12
SCAN
AUTO MEMORY
22
A.MEMO
EN09-15.KV-C10[J]f 00.11.28, 4:17 PM11