Filter
Top Products
26
ENGLISH
To make further precise settings for
the DSP modes
These settings you make are valid for all DSP
modes except “V.Cancel.”
Setting items:
The number of the built-in speakers:
Select the number of the speakers built in
your car—“2ch” or “4ch.”
• When you have four speakers (4ch) built
in your car, select your car size (see step 4
that follows).
Listening seat position:
Select the listening seat position where you
want to locate the sound image.
1 Repeat steps ~ to ! on page
25 to select DSP mode (except
“V.Cancel”).
2 Select the number of the built-in
speakers.
2ch:
Select for the two speaker
system.
4ch:
Select for the four speaker
system.
3
• If you select “2ch,” go
to step 5.
2ch
4ch
4 If you select “4ch,” select your car
size.
Middle:
Select when the distance
from the rear speakers to
the listening seat position is
almost equal to that from the
front speakers.
Large:
Select when the distance
from the rear speakers to
the listening seat position is
longer than that from the front
speakers.
Compact:
Select when the distance
from the rear speakers to
the listening seat position
is shorter than that from the
front speakers.
5 Select your listening seat position.
All:
For all front and rear seats.
Front:
For the both front seats.
R.Front:
For the front right seat.
L.Front:
For the front left seat.
6 Finish the procedure.
All Front
R.FrontL.Front
Middle Large
Compact
EN25-30_KD-SHX751[EX_EU]5.indd 26EN25-30_KD-SHX751[EX_EU]5.indd 26 05.2.10 4:25:30 PM05.2.10 4:25:30 PM