JVC XA-SD1 Car Stereo System User Manual


 
S
D
A
U
D
IO
P
L
A
Y
E
R
X
A
-S
D
1
MODE
HOLD
NOMR
CARD : PUSH RELEASE
VOLUME
2
3
MODE
NORM
HOLD
SD AUDIO PLAYER XA-SD1
MODE
HOLD
NOMR
CARD : PUSH RELEASE
1
SD AUDIO PLAYER XA-SD1
VOLUME
CAR
D : PU
SH RELEASE
Insert an SD memory card con-
taining data check-out (recording).
Playback
1
C
A
R
D
: P
U
S
H
R
E
LE
A
S
E
Set to NORM.
Extension cord
(supplied)
Press 3/7.
The unit is turned on and playback starts.
Adjusting the volume
Press and hold to vary continuously.
Ÿ Hold the SD memory card with the
label side up, then insert the card
from the side having cut corners.
~ Slide the card cover on the side of
the unit in the direction of the arrow
and open the card cover.
Open it while pushing the battery com-
partment cover.
! Insert the SD memory card by
pushing the center of its edge until
it locks, then close the card cover.
Connect headphones.
To use an extension cord, see below.
Note
Never insert the SD memory card upside
down. Otherwise, it will not be able to be
removed.
Immediately
after press
Approx. 2 sec.
later
Track No.
Elapsed play time
Track title
Volume level meter
Volume level (Adjustment range 0 to 25)
Insert the plug
firmly.
To
decrease
To
increase
Card cover
Stop playback
and turn the
unit off.
Press 3/7.
The unit is turned off automati-
cally in about 10 seconds.
Resume
When
3/7
is pressed again after the unit has
been turned off, playback resumes from the
position at which the unit was turned off.
However, playback starts from the first track if
the SD memory card is changed or batteries are
removed and inserted again while the unit is off.
To remove
the SD
memory card
While playback is stopped, open the card
cover (operations ~ in step 3 above) and
unlock and remove the SD memory card by
pushing its center area.
Card cover
4
5