Kenwood DDX315 Car Video System User Manual


 
54
CONNECTION/INSTALLATIONCONNECTION/INSTALLATION
RInstallation procedure
1 To prevent a short circuit, remove the key
from the ignition and disconnect the
·
battery.
2 Make the proper input and output wire
connections for each unit.
3 Connect the speaker wires of the wiring
harness.
4 Connect the wiring harness wires in the
following order: ground, battery, ignition.
5 Connect the wiring harness connector to
the unit.
6 Install the unit in your car.
Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
7 Reconnect the · battery.
8 Press the reset button.
9 Configure <Initial Setup>. (Page4)
Installing the unit
RInstalling the unit (only for DDX672BH/
DDX492/DDX392/DDX372BT/
DDX320BT/DDX272)
Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
R Installing the unit using the mounting
bracket removed from the car
Car Bracket
5 or 6
5 or 6
Select the appropriate type of screw for the
mounting bracket: flat head (5) or round head
(6).
RInstalling the trim plate
1 Attach the trim plate (2).
2