Kenwood DDX4053BT Car Video System User Manual


 
78 English
Installing the Microphone
Unit (DDX6023BT/
DDX6053BT/ DDX4023BT/
DDX4053BT/DDX42BT only)
1 Check the installation position of the
microphone (accessory 7).
2 Remove oil and other dirt from the
installation surface.
3 Install the microphone.
4 Wire the microphone cable up to the unit
with it secured at several positions using
tape or the like.
• Install the microphone as far as possible from the
mobile phone.
Fix a cable with clamps (commercially
available).
Peel the release coated paper of double-face
adhesive tape to fix on the place shown above.
Adjust the direction of the microphone to the
driver.
Accessory 7
Removing the Unit
(DDX4023BT/DDX4053BT/
DDX3023/DDX3053/
DDX42BT/DDX35 only)
For removing DDX6023BT/DDX6053BT, page 73.
1 Remove the trim plate by referring to
the removal procedure in the section
“Removing the Trim Plate”.
2 Insert the two extraction keys 4 deeply
into the slots on each side, as shown.
Accessory 4
3 Lower the extraction keyl toward the
bottom, and pull out the unit halfway
while pressing towards the inside.
Be careful to avoid injury from the catch pins on
the removal tool.
4 Pull the unit all the way out with your
hands, being careful not to drop it.
EN_GET0909-001A_EQ.indb 78EN_GET0909-001A_EQ.indb 78 12/11/13 15:2812/11/13 15:28