Kenwood DDX5034M Car Video System User Manual


 
70 DDX5034/DDX5034M
Setup Menu
Security Code Setup
You can set a security code to protect your
receiver system against theft.
• When the Security Code function is activated, the code
cannot be changed and the function cannot be released.
Note the Security Code can be set as the 4 digit number
of your choice.
1 Display the Security Code Setup screen
Touch
in the "Setup
Menu" screen (page 56).
1
2
1 Displays the Security code input screen.
2 Turns the SI function on or off.
If turned "ON", the burglar alarm lamp
flashes when the vehicle ignition is off.
( "ON")
2 Start Security Code setup
• If you have already completed the code registration,
is displayed.
3 Enter a security Code
Input four-digit number.
4 Register your security code
5 Reenter the security code
Reenter the same security code as that you
have entered in Step 3 for confirmation.
• If you enter a different security code, the screen returns
to Step 3 (for the first code entry).
6 Register the security code again
Now, your security code is registered.
If you press the Reset button or if you
disconnect your receiver from the battery after
the code registration, you need to enter the
registered security code.
If you have pressed the Reset button or if
you have disconnected the Receiver from
battery...
1 Enter the correct security code
You must enter the same security code as that
you have entered in Step 3.
2 Enter the security code
Now, you can use your Receiver.