Filter
Top Products
English 63
If is not shown, touch
or
to display it.
1
Returns to the Control screen of the previous
source.
2
Calls the Sound Effects Menu. (see page 68)
3
Calls the Setup Menu.
4
Allows you to start security code registration.
5
Turns the SI function On or Off.
If turned "On", the burglar alarm lamp flashes
when the vehicle ignition is off.
If you have already completed the code
registration, the is not displayed.
1
Enters a security code.
2
Clears your entry.
3
Cancels the registration and returns to the
Security Code Setup screen.
4
Enters the security code.
—
Input a four-digit number.
90
Enter a security code
3
Set
Start the security code registration
2
Set
Security Set Up
Security Set Up
Display the Security Code Setup screen
1
Reenter the same security code as that you have
entered in Step 3 for confirmation.
If you enter a different security code, the screen
returns to Step 3 (for the first code entry).
Your security code has been registered.
If you press the Reset button or if you disconnect
your Receiver from the battery after the code
registration, you need to enter the registered
security code. See below for details.
If you have pressed the Reset button or if you
have disconnected the Receiver from battery...
—
You must enter the same security code as that you
have entered in Step 3 above.
Now, you can use your Receiver.
If you enter an incorrect security code, you
cannot use your Receiver for a while.
Incorrect entry count Receiver inoperable
time
1—
25 minutes
31 hour
4 or more 24 hours
Enter
Enter the security code
2
90
Enter the correct security code
1
Enter
Register the security code again
6
Reenter the security code
5
Enter
Register your security code
4
Menu
Security Code
Security
Set
Set Up
SRC
Audio
SI
OffOn
2
1
3
4
5
5
EnterCancelClear
* * * *1st
1
2
3
4
5
6
7
8
0
9
Pass Word
2
3
4
1
DDX7035/7045/7065_M(En)v2.6 04.4.18 8:49 PM ページ63