Filter
Top Products
10
English
L
R
L
R
LINE IN
P.CON EXT.AMP.CONT.
GND
MONO
LINE OUT
25Hz
15Hz
INFRASONIC FILTER OPERATION
OFF
0.2
0.5
5
1
2
3
4
BB AA +
(MAX)(MIN)
25Hz
15Hz
INFRASONIC
FREQ (Hz) FREQ (Hz)
OFF
LPF
OFF
HPF
MONO
STEREO
FILTER
LPF
OFF
HPF
OPERATION
MONO
STEREO
B.M.S.
B.M.S.
FREQ(Hz)
B.M.S.
(
+
6)
CLOSE
OPEN/ B.M.S.
(REMOTE)
INPUT SELECT
A
AB
CONTROL
INPUT SENSITIVITY(V)
0.2
0.5
5
1
2
3
4
10050
80
(MAX)(MIN)
INPUT SENSITIVITY(V)
A
CONTROL
B
G
N
D
■
RCA cable connection
CENTRE UNIT
(Cassette receiver,
CD receiver, etc.)
RCA cable *
RCA cable ground terminal
When using an RCA cable with a ground lead attached, connect the ground lead to this
terminal.
Do not use this terminal for power source grounding. This unit will be damaged if the power
source grounding cable is connected to this terminal.
2CAUTION
Front output
Rear output
A Left input
B Left input
Connection
RCA cable ground terminal
Power control cable
(To Power control terminal)
A Right input
B Right input
■
Speaker Selection
• The rated input power of the speakers that are going to be connected should be greater than
the maximum output power (in Watts) of the amplifier. Use of speakers having input power
ratings that are less than the output power of the amplifier will cause smoke to be emitted as
well as damage.
• The impedance of the speakers that are going to be connected should be 2Ω or greater (for
stereo connections), or 4Ω or greater (for bridged connections). When more than one set of
speakers are going to be used, calculate the combined impedance of the speakers and then
connect suitable speakers to the amplifier.
Examples:
Stereo Connections (4
Ω
) Bridged Connections (4
Ω
)
200 W or greater 600 W or greater
200W
(4Ω)
4 Ω
200W
(4Ω)
200W
(4Ω)
200W
(4Ω)
4 Ω
4 Ω
200W
(2Ω)
100W
(8Ω)
100W
(8Ω)
200W
(2Ω)
Maximum output of
the amplifier
Combined
impedance
Rated input power and
impedance of the speakers
* : Commercially available parts