Filter
Top Products
Adjust the time manually.
This adjustment is available only when the automatic time
adjustment is set to off. (page 37)
Display and setting:
Select the display "Clock Adjust" during the selecting function
in the menu system.
Hold down either the 4 or ¢ button for one second or
more to enter the Manual time adjustment mode.
The time display will blink.
• Adjusting the hours
Press the FM button to advance the hours, or press the AM
button to make the hours go back.
• Adjusting the minutes
Press the ¢ button to advance the minutes, or press the
4 button to make the minutes go back.
Press the MENU button to end the Manual Time Adjustment
mode.
Exiting the Manual Time Adjustment mode would start the
clock counting.
4
3
2
1
NOTE
Manual Time Adjustment
This function produces a beep sound that accompanies button
operation. It can be switched on or off.
Display and setting:
"Beep ON" : Beep setting is on. (Default setting)
"Beep OFF" : Beep setting is off.
The beep sound is not output from the preout jacks.
NOTE
Touch Sensor Tone
• Keep the Mask Key close to the signal sensor when you
transmit the Mask Key’s signal.
• If the Mask Key’s signal does not be received correctly, the
display will return to "TRANSMIT 1" . In this case, repeat the
procedure in step 4.
Hold down the transmit button on the Mask key again until the
full transmit level indicator lights up in the display.
"APPROVED" will appear in the display, with the Mask key
function turning on.
If you press the RESET button or remove the battery:
The first time you turn the unit on again, "TRANSMIT 1" will
appear in the display, indicating the setting mode has been
entered. Repeat steps 4 and 5 above, and transmit the signal.
You can start operating the unit again when "APPROVED"
appears in the display.
5
NOTE
Transmit button
Transmission part
— 35 —