Filter
Top Products
English
|
19
Adjusting the detail of Audio Control
You can adjust the following Basic Audio Items in
datail: Bass level, Middle level, and Treble leval.
Bass level
Adjustment Item Display Range
Bass Center Frequency “BASS F” 40/50/60/70/80/100/
120/150 Hz
Bass Q Factor “BASS Q” 1.00/1.25/1.50/2.00
Bass Extend “BASS EXT” OFF/ON
Middle level
Adjustment Item Display Range
Middle Center Frequency “MID F” 0.5/1.0/1.5/2.0 kHz
Middle Q Factor “MID Q” 1.0/2.0
Treble level
Adjustment Item Display Range
Treble Center Frequency “TRE F” 10.0/12.5/15.0/17.5 kHz
1 Select the Basic Audio item
For how to select Basic Audio items, see <Audio
Control> (page 18).
2 Enter Detail adjustment mode of Audio
Control
Press the [AUD] knob for at least 1 second.
3 Select the Detail Audio item to adjust
Press the [AUD] knob.
4 Adjust the Detail Audio item
Turn the [AUD] knob.
5 Exit the Detail Audio Control mode
Press the [AUD] knob for at least 1 second.
⁄
• When you set the Bass Extend to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime by
pressing any button except for [AUD] knob or [0]
button.
Audio Setup
You can set Sound system , such as follows;
Adjustment Item Display Range
Front High Pass Filter “HPF F” Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter “HPF R” Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter “LPF SW” 50/60/80/100/120/ Through
Hz
Subwoofer Phase “SW PHASE” Reverse (180°)/ Normal (0°)
Volume offset “V-OFFSET” –8 — ±0 (AUX: -8— +8)
Dual Zone System “2ZONE” OFF/ON
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by “ZONE2” of
<Function Control> (page 6).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [AUD] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page18) or [5]/[∞] button on the remote control
(page 28).
- The Audio Control has no effect on sub source.
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the [AUD] knob.
4 Adjust the Audio setup item
Turn the [AUD] knob.
5 Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.