Filter
Top Products
6
Angle adjustment switches
It is not possible to install at an angle of 40°~50° if only A is used.
90
0
45
90
0
45
90
0
45
Installation angle
Angle adjustment switch position
85°~90°40°~50°0°~5°
90
0
45
90
0
45
Installation
■
Accessories
A × 1 B × 4 C × 4 D × 1 E × 1 F × 1
■
Installation Procedure
1
Removing the transportation screws
Remove all 3 transportation screws for
protecting the internal mechanism before
you start to install the unit.
After removing the transport screw, retain it
carefully and attach it again before
transporting the unit again.
2
Angle adjustment switches
• The angle adjustment switches on the both
side of the unit are to be set according to
the angle of installation of the CD auto
changer. Set both of the two switches to
the same position. If the switches are not
set properly, sound skip or other
malfunction may occur.
• Set the angle adjustment switches with a
coin or other flat object.
• Change the switch step by step by
detaching and reusing the object at the end
of each step.
NOTE
Transportation
screws
'
3 Cover the holes indicated by 3 with
the dustproof seals E. (Bottom and
sides)
Use the holes marked ● to install the
unit. (See page 14)
Do not tighten the screw B too
securely at the time of installation, but
tighten it securely after having fixed the
bracket A.
2CAUTION