Filter
Top Products
8
PROBLEM POSSIBLE CAUSE SOLUTION
Sound skips due to vibration.
The disc changer mode cannot
be selected.
• The unit is mounted at a slant.
• Changer unit is mounted in an
unstable place.
• The angle adjustment switches are
set improperly.
The O-N selection switch of the disc
changer is not set properly.
• Mount the unit so that is level.
• Mount the unit in a stable place.
• Set the angle adjustment switches to
the correct positions.
Set the O-N selection switch to "O"
position.
When removing the CD changer, be sure to first eject a magazine then unplug the changer cord. Do not forget to
attach the transport screws before transporting the CD changer.
The CD changer may be damaged during transport if a magazine or CD is left inside it or the transport screws are not
attached.
Troubleshooting Guide
Specifications
Laser diode ..........................GaAlAs (λ=780 nm)
Digital Filter ......................8 Time Over Sampling
D/A Converter ..............................................1 bit
Spindle speed ....................500 ~ 200 rpm (CLV)
Wow & Flutter ..............Below Measurable Limit
Frequency Response (±1 dB)........5 Hz ~ 20 kHz
Total harmonic distortion (1 kHz)............0.005 %
Signal to Noise Ratio ..................................94 dB
Dynamic range ..........................................94 dB
Channel separation ....................................85 dB
Operating voltage ....14.4 V (11 ~ 16 V allowable)
Current consumption ........0.8 A at Rated power
Dimensions (W × H × D)
(KDC-C712) ......................250 × 80 × 176 mm
(KDC-C662/C462) ............250 × 64 × 176 mm
Weight
(KDC-C712)............................................2.0 kg
(KDC-C662/C462) ..................................1.8 kg
Specifications subject to change without notice.