Filter
Top Products
2
|
English
2WARNING
To prevent injury or fire, take the following
precautions:
• To prevent a short circuit, never put or leave any
metallic objects (such as coins or metal tools) inside
the unit.
• If the unit starts to emit smoke or strange smells,
turn off the power immediately and consult your
Kenwood dealer.
2CAUTION
To prevent damage to the machine, take
the following precautions:
• Do not open the top or bottom covers of the unit.
• Do not install the unit in a spot exposed to direct
sunlight or excessive heat or humidity. Also avoid
places with too much dust or the possibility of
water splashing.
• Do not use your own screws. Use only the screws
provided. If you use the wrong screws, you could
damage the unit.
• When drilling a hole in the car to fix the brackets,
make sure not to damage the fuel tank, brake tube,
wiring harnesses, etc. on the other side.
• If the unit is installed near speakers, the speakers
vibration may causes a sound skip. Install the unit as
far away as possible from the speakers.
About a control unit that can be connected
to this unit
Note that any control units released in 1997 or earlier
cannot be connected to this unit.
Unsupported connection may result in damage.
• FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN
DAMAGE TO THIS UNIT AND CONTROL UNIT.
Do Not Load 8 cm (3 in.) CDs
If you try to load a 8 cm (3 in.) CD with its adapter into
the unit, the adapter might separate from the CD and
damage the unit.
NOTE
• If you have difficulty in installing this unit in your
vehicle, contact your Kenwood dealer.
• If it doesn’t seem to be working properly, first press
the Reset button. If the malfunction persists, consult
your Kenwood dealer.
Lens Fogging
Right after you turn on the car heater in cold weather,
dew or condensation may form on the lens in the CD
player of the unit. Called lens fogging, CDs may be
impossible to play. In such a situation, remove the disc
and wait for the condensation to evaporate. If the unit
still does not operate normally after a while, consult
your Kenwood dealer.
Heat protection
In warm climates, when vehicles are left standing
in direct sunlight with the windows closed, the
temperature inside can rise above 60°C. The unit’s
protection circuits will then display the message
"HOLD" and prevent the player from operating. Just
open the windows or turn on the air conditioning. As
soon as the "HOLD" message disappears, the player
will operate normally.
Cleaning the Unit
If the front panel is dirty, wipe it clean with a silicon
cloth or soft dry cloth with the power off.
• Do not use hard cloths or paint thinner, alcohol, or other
volatile solvents. These may damage external surfaces or
remove indicator characters.
The marking of products using lasers
(Except for some areas)
CLASS 1
LASER PRODUCT
The label is attached to the chassis/case and says
that the component uses laser beams that have been
classified as Class 1. It means that the unit is utilizing
laser beams that are of a weaker class. There is no
danger of hazardous radiation outside the unit.
Safety precautions