Filter
Top Products
This adjustment can be done when the <Synchronize Clock> (page
31) is set as OFF.
1 Select Clock Adjustment mode
Press the [FM] or [AM] button.
Select the "Clock Adjust" display.
Manual Clock Adjustment
Setting the operation check sound (beep sound) ON/OFF.
Display Setting
"Beep ON" Beep is heard.
"Beep OFF" Beep canceled.
Touch Sensor Tone
5 Reenter the Mask Key's signal
Hold down the transmit button on the Mask Key until the full
transmit level indicator lights up in the display.
"BAR BAR BAR"/"APPROVED" is displayed, and the Mask Key
function activates.
Press the Reset button and when it's removed from the
battery power source
1 Turn the power ON
The vehicle engine turns ON.
"BAR BAR 1"/"TRANSMIT1" is displayed.
2 Enter the Mask Key's signal
Repeat steps 4 and 5 above, and enter the Mask Key's signal.
"BAR BAR BAR"/"APPROVED" is displayed.
The unit can be used.
Because authorization by the Mask Key is required when it's
removed from the vehicle, personalizing this unit by using the
Mask Key is a help in preventing theft.
1 Enter Standby
Press the [SRC] button.
Select the "ALL OFF" display.
2 Enter Menu mode
Press the [MENU] button for at least 1 second.
When "MENU" is displayed, "Mask key" is displayed.
3 Enter Mask key mode
Press the [4] or [¢] button for at least 1 second.
"BAR BAR 1"/"TRANSMIT1" is displayed.
4 Enter the Mask Key's signal
Hold down the transmit button on the Mask Key until the full
transmit level indicator lights up in the display.
"BAR BAR 2"/"TRANSMIT2" is displayed.
• Keep the Mask Key close to the signal sensor when you transmit
the Mask Key's signal.
• If the Mask Key's signal does not be received correctly, the display
will return to "BAR BAR 1"/"TRANSMIT1" . In this case, repeat
the procedure in step 4.
Mask Key
Menu system
— 30 —
English
KDC-M9021SE_U.S 03.1.17 3:19 PM Page 30