Filter
Top Products
15
ENGLISH
Connecting the ISO connectors on some VW/Audi or
Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring
harness as illustrated below.
Installing the unit
Installing without using the
mounting sleeve (Japanese car)
(KDC-MP249/ KDC-MP2049/ KDC-MP149 only)
1
Remove the mounting sleeve and
escutcheon from the unit.
2
Align the holes in the unit (on both
sides) with the vehicle mounting bracket
and secure the unit with the supplied
screws.
2
1
Connect the wiring harness to the unit. Other wiring
connection has been completed earlier. (page 14)
Before attaching, make sure
the direction of the
escutcheon is correct. (Wider
hooks on the top side.)
Dashboard of your car
T:
Toyota cars
N:
Nissan cars
Unit Vehicle
A7 (Red)
Ignition wire
(Red)
A4 (Yellow)
Default wiring
Battery wire
(Yellow)
Removing the unit
1
Detach the faceplate.
2
Engage the catch pin on the removal
tools into the holes on both sides of the
escutcheon, then pull it out.
3
Insert the removal tools deeply into
the slots on each side, then follow the
arrows instructions as shown below.
ISO connectors
Pin
Color and function
A4
A5
A7
A8
Yellow
Blue/White
Red
Black
Battery
Power control
Ignition (ACC)
Earth (ground) connection
B1 / B2
B3 / B4
B5 / B6
B7 / B8
Purple
ª
/ Purple/black ·
Gray
ª
/ Gray/black ·
White
ª
/ White/black ·
Green
ª
/ Green/black ·
Rear speaker (right)
Front speaker (right)
Front speaker (left)
Rear speaker (left)
Bend the appropriate tabs
to hold the mounting
sleeve firmly in place.
EN02-15_KDC-MP249[M]f.indd 15EN02-15_KDC-MP249[M]f.indd 15 8/10/10 10:24:04 AM8/10/10 10:24:04 AM