Filter
Top Products
22 English
Easy Pairing function
• KDC-U549BT only.
1 Press and hold to enter easy pairing
mode
“PAIRING” is displayed.
■
Any of the following is displayed
depending on cell-phone registration
condition:
–
“SEARCHING”: When registering a cell-
phone for the first time.
–
“(cell-phone name)”: When a cell-phone
has already been registered.
–
“DEVICE FULL”: When maximum of
five cell-phones have already been
registered.
When registering a cell-phone for the first
time, registering a cell-phone
2 “SEARCHING” is displayed.
Search for the Bluetooth device.
When search is completed, “FINISHED” is
displayed.
3 Turn the volume knob to select a cell-
phone name, press to confirm.
4 Input the PIN code
■
Turn the volume knob to select the
number.
■
To move to the next digit, press ¢.
■
To delete the last digit, press 4.
5 Press the volume knob to transmit the
PIN code.
If “PAIRING OK” is displayed, registration is
completed.
When “CONFIRM PHONE” is displayed,
confirm connection with a cell-phone
operation.
6 The receiver is connected to a cell-phone,
with “HF CONNECT” displayed, and exits
the easy pairing mode.
■
If an error code is displayed during paring,
see <Troubleshooting> (page 34).
When a cell-phone has already been
registered, or maximum of five cell-phones
have already been registered/ selecting a
cell-phone
2 “(cell-phone name)” or “DEVICE FULL” is
displayed.
3 Turn the volume knob to select a cell-
phone name.
■
To register a new cell-phone, select “[DVC
SEARCH]”, then go to “When registering a
cell-phone for the first time.”
4 Press the volume knob to set up the
cell-phone.
■
“✱(cell-phone name)”: The selected
Bluetooth device is busy.
■
“-(cell-phone name)”: The selected
Bluetooth device is on standby.
■
“ (cell-phone name)“: The Bluetooth
device is deselected.
■
If a cell-phone is already selected,
deselect it, and then select a different
one.
5 Press to exit easy pairing mode.
Deleting the registered cell-phone
2 “(cell-phone name)” or “DEVICE FULL” is
displayed.
3 Turn the volume knob to select a cell-
phone name.
4 Press and hold the volume knob to delete
the selected cell-phone.
“DELETE” is displayed.
5 Turn the volume knob to select “YES”,
then press to confirm.
“COMPLETED” is displayed.
Bluetooth Setup
Preparation : KDC-U4549SD/ KDC-U4549: Only with the optional accessory KCA-BT300 or KCA-
BT200 connected.