Filter
Top Products
English 25
Item Selectable setting (Preset: *)
PAIRING
DEVICE SEARCH Registers a Bluetooth device (pairing).
(For details, see page 23.)
PHONE SELECT Selects a cell-phone connection.
(For details, see page 24.)
AUDIO SELECT KDC-U4549SD/ KDC-U4549 only:
Selects a Bluetooth audio player connection. (For details, see page 24.)
S-DVC SELECT (For details, see page 23.)
DEVICE DELETE Cancel registration of the Bluetooth device.
1. Turn the volume knob to select the Bluetooth device, then press to confirm.
2. Turn the volume knob to select “YES”, then press to confirm.
SMS DOWNLOAD Download a short message. (For details, see page 27.)
VOICE TAG
PB NAME EDIT Registers voice for voice recognition and voice to select the Phone number category in Phone book.
(For details, see page 24.)
PN TYPE EDIT
DETAILED SET
PIN CODE EDIT Specify the PIN code required when registering this unit using the Bluetooth device. By default, “0000” is
specified.
1. Turn the volume knob to select the number.
■
To move to the next digit, press
¢
.
■
To delete the last digit, press
4
.
2. Press the volume knob to register a PIN code
AUTO ANSWER OFF: Does not answer the phone call automatically. ; 0: Automatically answers the phone call at once. ;
1 – 8 * –99: Automatically answers the phone call after lapse of 1 – 99 seconds.
then press to confirm. (KDC-U4549SD/
KDC-U4549 only)
7 “ENTER 1” is displayed. When a beep is
heard, say a voice tag within 2 seconds.
8 “ENTER 2” is displayed. When a beep is
heard, say the same voice tag as that you
said in step 7 within 2 seconds.
“COMPLETE” is displayed.
9 Press the volume knob to return to step
5.
■
Set the voice tag for all the 5 categories. If
the voice tag is not registered for all the
categories, the Phone book may not be
recalled by voice command.
Bluetooth Setup
1 KDC-U549BT
Press to enter Bluetooth mode.
KDC-U4549SD / KDC-U4549
Press and hold the volume knob to enter
Bluetooth mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
3 Turn the volume knob to make a
selection, then press to confirm.
■
See table below for selection.
■
Repeat step 3 until the desired item is
selected/activated.
■
Press to return to the previous item.
4 Hold to finish the procedure.
■
To exit Bluetooth mode, press SRC.
Continued to next page