Filter
Top Products
Troubleshooting Guide
The messages shown below display your
systems condition.
Eject: • No disc magazine has been loaded in
the changer. The disc magazine is not
completely loaded.
• No CD in the unit.
No Disc: No disc has been loaded in the disc
magazine.
TOC Error: • No disc has been loaded in the disc
magazine.
• The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
Read Error: • The number of files or folders which are
stored in the connected USB device is above
the limitation.
• The file system of the connected USB device
is broken.
➪ Copy the files and folders for the USB
device again referring to http://www.
kenwood.com/usb/. If the error message is
still displayed, initialize the USB device or
use other USB devices.
Error 05: The disc is unreadable.
Blank Disc: Nothing has been recorded on the MD.
No Track: No tracks are recorded on the MD, although it
has a title.
Error 15: Media was played that doesn’t have data
recorded that the unit can play.
No Panel: The faceplate of the slave unit being
connected to this unit has been removed.
Error 77: The unit is malfunctioning for some reason.
➪ Press the reset button on the unit. If the
"Error 77" code does not disappear, consult
your nearest service center.
Mecha Error: Something is wrong with the disc magazine.
Or the unit is malfunctioning for some reason.
➪ Check the disc magazine. And then press
the reset button on the unit. If the "Mecha
Error" code does not disappear, consult
your nearest service center.
Hold Error: The protective circuit in the unit activates
when the temperature inside the automatic
disc changer exceeds 60°C (140°F), stopping
all operation.
➪ Cool down the unit by opening the
windows or turning on the air conditioner.
As the temperature falls below 60°C
(140°F), the disc will start playing again.
No Name: Attempted to display DNPS during the CD
play having no disc names preset.
Load: Discs are being exchanged in the Disc
changer.
Waiting: Radio text data is being received.
Reading: The unit is reading the data on the disc.
IN (Blink): The CD player section is not operating
properly.
➪ Reinsert the CD. If the CD cannot be
ejected or the display continues to flash
even when the CD has been properly
reinserted, please switch off the power
and consult your nearest service center.
Protect (Blink): The speaker wire has a short-circuit or
touches the chassis of the vehicle, and then
the protection function is activated.
➪ Wire or insulate the speaker cable properly
and press the reset button. If the "Protect"
code does not disappear, consult your
nearest service center.
Unsupported File:
An Audio file is played with a format that this
unit can’t support.
➪ ----
Copy Protection:
A copy-protected file is played.
➪ ----
DEMO MODE (Blink):
The Demonstration mode has been selected.
➪ The <Demonstration mode Setting> (page
35) is ON. Turn it OFF.
44
|
English