Filter
Top Products
6
|
KMR-330
General Operation
Audio Control
You can adjust following Audio Control items;
Adjustment Item Display Range
Subwoofer level “SUB-W L” –15 — +15
Bass Boost “B.BOOST-L” “L1”/”L2”/“OFF”
(The indicator turns on
according to the setting.)
System Q “NATURAL”/
“USER”/“ROCK”/
“POPS”/“EASY”/
“TOP40”/“JAZZ”
Natural/User setting/Rock/
Pops/Easy/Top 40/Jazz
(The indicator turns on
according to the setting.)
Bass level “BASS L” –8 — +8
Middle level “MID L” –8 — +8
Treble level “TRE L” –8 — +8
Balance “BALANCE” Left 15 — Right 15
Fader “FADER” Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
⁄
• “USER”: The customized Bass, Middle, and Treble levels
are effective. This item is displayed only when the tone
quality has been adjusted.
This item disappears when another setting is selected.
• You can set Bass, Middle, and Treble for each source.
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Control mode
Press the Control knob.
3 Select the Audio item to adjust
Press the Control knob.
4 Adjust the Audio item
Turn the Control knob.
5 Exit Audio Control mode
Press any button.
Press a button other than the Control knob or 0
button.
Audio Setup
You can set Sound system, such as follows;
Adjustment Item Display Range
Low Pass Filter “LPF SW” 80/120/160/Through Hz
Volume offset “V-OFFSET” –8 — ±0 (AUX: -8— +8)
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Setup mode
Press the Control knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the Control knob.
4 Adjust the Audio setup item
Turn the Control knob.
5 Exit Audio Setup mode
Press the Control knob for at least 1 second.
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Speaker type Display
OFF “SP SEL OFF”
For 5 & 4 in. speaker “SP SEL 5/4”
For 6 & 6x9 in. speaker “SP SEL 6*9/6”
For the OEM speaker “SP SEL OEM”
1 Enter Standby
Press the [SRC] button.
Select the “STANDBY” display.
2 Enter Speaker Setting mode
Press the Control knob.
3 Select the Speaker type
Turn the Control knob.
4 Exit Speaker Setting mode
Press the Control knob.