Filter
Top Products
Troubleshooting Guide
English
9
PROBLEM POSSIBLE CAUSE SOLUTION
The sound quality is poor or
distorted.
Radio reception is poor.
The memory is erased when
the ignition is turned off.
• A speaker cable may be pinched by
a screw in the car.
• The speakers are not cabled
correctly.
• The car antenna is not extended.
• The antenna control cable is not
connected.
• Adverse effect of noise from power
cable, etc.
• The battery cable has not been
connected to the proper terminal.
• The ignition and battery cable are
incorrectly connected.
• Check the speaker wiring..
• Reconnect the speaker cables so
that each output terminal is
connected to a different speaker.
• Pull out the antenna all the way.
• Connect the cable correctly,
referring to the section on
"Connecting Cables to Terminals".
• Be sure to install the antenna cable
away from the power cable.
• Connect the cable correctly,
referring to the section on
"Connecting Cables to Terminals".
• Connect the cable correctly,
referring to the section on
"Connecting Cables to Terminals".
The following indications are used to inform you that there is a problem with the connections
of the system.
BUS-E01: The M-S switch of the Monitor connected to the BUS terminal is set to "M".
] Switch the Monitor’s M-S switch to "S".
The "MASTER SW" cable of the monitor power supply harness is connected to -.
] Do not connect the "MASTER SW" cable.
BUS-E50: Two or more center units are connected.
BUS-W02: The No. switch of the connected disc changers is set to the same number (1 or 2) for
both units.
] Set the No. switch of one disc changer to "1" and the other unit to "2" to enable proper
use.
BUS-W08: Two or more Monitors are connected to the BUS terminal.
FM tuner section
Frequency range (50 kHz Space)
..............................................87.5 MHz – 108.0 MHz
Usable sensitivity (S/N = 26dB) ..............0.7 µV/75 Ω
Quieting Sensitivity (S/N = 46dB)............1.6 µV/75 Ω
Frequency response (±3.0 dB) ..........30 Hz – 15 kHz
Signal to Noise ratio (MONO) ..........................65 dB
Selectivity (DIN) (±400 kHz) ........................ ≥ 80 dB
Stereo separation (1 kHz) ................................35 dB
MW tuner section
Frequency range (9 kHz Space)
..................................................531 kHz – 1611 kHz
Usable sensitivity (S/N = 20dB)........................25 µV
LW tuner section
Frequency range ..........................153 kHz – 281 kHz
Usable sensitivity (S/N = 20dB)........................45 µV
Audio section
Maximum output power..............................44 W × 4
Output power (DIN 45324, +B=14.4 V) ......28 W × 4
Tone action
Bass: ......................................100 Hz ±10 dB
Treble:......................................10 kHz ±10 dB
Preout level / load..........4 V / 10 kΩ (During CD play)
Preout Impedance ..........................................≤ 80 Ω
General
Operating voltage............14.4 V (11 – 16 V allowable)
Current consumption ................10 A at Rated power
Installation size (W × H × D)........213 × 40 × 148 mm
Weight..............................................................990 g
Specifications subject to change without notice.
Specifications