Filter
Top Products
4
|
English
Connection
FM /AM ANTENNA
AV INPUT 1
AV INPUT 2
LR
R
R
VIDEO
VIDEO
FRONT
REAR
PRE OUTPUT
AV OUTPUT
POWER
R-CAM V-IN
L
L
R
L
R
L
VIDEO
+
A
B
C
SUB
[MONO]
CENTER
B
C
ANTCONT
P.CONT
EXT.CONT
(10A)
MUTE
PRKSW
REVERSE
(5A)
ACC
BATT
ILLUMI
REMO.CONT
A
B
C
30R
Accessory 4
(Black)
Accessory %
(KVT-817DVD only)
Optical output
(KVT-817DVD only)
An Optical cable (Accessory 3) is fixed with a chassis using
harness band (Accessory ^). (KVT-817DVD only)
Ground wire (Black) - (To car chassis)
Battery wire (Yellow)
Mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
External amplifier control wire (Pink/Black)
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
To connect the Kenwood navigation system,
consult your navigation manual.
Depending on what antenna you are using, connect either to the
control terminal of the motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
When using the optional power amplifier, connect to its power
control terminal.
To "EXT.AMP.CONT." terminal of the amplifier having the external
amp control function.
FM/AM antenna input
Antenna Cord
Ignition key switch
Car fuse box
(Main fuse)
ACC
Car fuse box
Connect to the vehicle's parking brake detection
switch harness using the supplied relay connector.
Ground wire (Black) - (To car chassis)
Steering remote control input
(Light Blue/Yellow)
Dimmer control wire (Orange/White)
Reverse sensor wire (Pink)
For the sake of safety, be sure to
connect the parking sensor.
Parking sensor wire (Green)
To car light control switch
To vehicle's reverse lamp harness
To Steering remote
Battery wire (Yellow)
Ignition wire (Red)
Receiver unit (front side)
Monitor unit
Accessory 5
Accessory 1
Battery
To Subwoofer system
When handling an optical cable for wiring, use care not
to exceed the minimum cable bend radius of 30 mm.
If you exceed the minimum bend limit, optical fibers
within the optical cable may be damaged.