Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
68
S-METER SQUELCH
By activating S-meter Squelch, the squelch does not open
until a signal with the same or greater strength than the
S-meter setting is received. This function is useful to
eliminate constantly resetting the squelch when receiving
weak stations that you have no interest in. You can set a
different S-meter value on each band.
1 Select the desired band.
2 Press [MNU] to enter Menu mode.
3 Select Menu No. 13 (S-Meter).
4 Press
[
ss
ss
s
]
, then select Item No. 1 (S-Meter SQL).
5 Press
[SET]
to toggle the function ON or OFF (default).
6 Press [MNU] again to exit Menu mode.
• The S-meter setting scale appears.
7 To select the desired S-meter setting, turn the left (VHF)
or right (UHF) SQL control depending on which band
you selected.
■ Squelch Hang Time
When using S-meter Squelch, you may want to adjust
the time interval between when the received signals
drop and when the squelch closes.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 13 (S-Meter).
3 Press
[
ss
ss
s
]
, then select Item No. 2 (Hang Time).
4 Press
[SET]
to select from OFF, 125 ms, 250 ms
and 500 ms. The default is OFF.
5 Press [MNU] again to exit Menu mode.
Note: You cannot select Item No. 2 (Hang Time) unless first you
switch S-meter Squelch ON.
PWRPWR
VOL SQL
CALLCALL
PWRPWR
VOL SQL
CALLCALL
1
2
PWRPWR
VOL SQL
CALLCALL
1
2