Filter
Top Products
4
INSTALLATION
Removing the unit
1. Frame
2. Insert fingers into the groove in the
right side of the frame and pull out to
remove the frame. (You can also
remove the frame from the left side.)
3. Lever
After removing the frame and when
the front panel is hidden, then insert
the levers supplied with the unit into
the grooves at both sides of the unit
as shown in figure until they click.
Pulling the levers makes it possible to
remove the unit from the dashboard.
DIN REAR-MOUNT (Method B)
1. Factory-installed radio bracket
2. Car radio mounting bracket
3. Screw
4. After aligning the car radio mounting
bracket with the factory-installed radio
bracket, tighten the screws (5 x 5mm)
at 2 places on each side.
5. When fixed factory-installed radio
bracket with the screws, use a
standard-tipped screwdriver to pry the
tabs of the car radio mounting bracket
to make them fit into the holes in the
factory-installed radio bracket.
6. Movable panel frame
1
2
3
Tab
2
1
3
4
5
6