Filter
Top Products
LOCATION AND FUNCTION OF CONTROLS
SPECIFICATION
GENERAL
Power requirement.................................................................................................DC 12V.
Chassis dimensions...................................................................183[W] X 53[H] X 160[D]mm.
FM SECTION
Frequency range........................................................................................88MHz -108MHz.
Usable sensitivity.........................................................................................................10uV.
I.F Frequency........................................................................................................10.7MHz.
AM SECTION
Frequency range.....................................................................................530KHz - 1700KHz.
LINE - OUT [OPTION]
Output................................................................................250mV @ FM 10% THD POWER.
Impedance............................................................................................................600 ohm.
CD PLAYER
System........................................................................................compact disc audio system.
Usable disc......................................................................................................compact disc.
Signal format.............................................................................sampling frequency 44.1KHz.
No of quantization bits 1bit.
Frequency characteristics...............................................................................5-40Hz < 5dB
10K-20KHz < 5dB.
Signal to noise radio................................................................70dB [1KHz] [IEC - A net work].
Current consumption..............................................................................................7A MAX.
POWER OUTPUT.....................................................................................................4 X 7W.
1
6
WIRING DIAGRAM
+
YELLOW
ANTENNA PLUG
MEMORY B+
BLACK(GND)
ACC RED (B+)
RCA LINE OUT
RED R
WHITE L
FRONT
REAR
RIGHT
SP
BLUE AUTO ANT
FRONT
WHITE
WHITE/BLACK
GREEN/BLACK VIOLET/BLACK
GREY/BLACK
GREY
VIOLET
GREEN
REAR
LEFT
SP
7 A
FUSE
FUSE
0.5 A
-
+
-
+
-
+
-
1. RELEASE BUTTON
Press this button to release the front panel when you want to take it away for
safekeeping.
2. TUNING CONTROL
Rotate this control at radio mode to select your desired radio broadcasting
station. And the frequency which has been selected will appear on the display.
3.4. SEL( AUDIO MODE SELECT)/VOLUME V.+/V.- BUTTON
Press SEL button to change the mode in sequence as follows:
VOL BAS TRE BAL FAD VOL
a. The volume can be adjusted at any time by pressing the audio level V.+ or
V.- button as select mode has been initially defaulted at volume mode.
b. The volume can be also obtained by stepping through the SEL button, after
the character VOL appeared on the LCD display, press V.+ or V.- button
to adjust the volume.
c. Press and hold the V.+ or V.- button to direct adjust the volume.
BASS CONTROL (WITHOUT APPLY EQ)
a. Press SEL button to select the bass mode until BAS appears on the display.
b. Press V.+ or V.- to adjust the bass effect.
TREBLE CONTROL (WITHOUT APPLY EQ)
a. Press SEL button to select the treble mode until TRE appears on the display.
c. Press V.+ or V.- to adjust the treble effect.
Note:
1.Make sure use a speaker with 4 ohm load impedance to reduce
the distortion during high volume level.
2.Do not make the auto antenna wire and ground touch each other.