Filter
Top Products
INSTALLATION MENU
8
INSTALLATION MENU
0055.. SSttaarrtt VVoolluummee
This function allows the Installer to determine the initial volume
level setting when the TV is turned ON. This feature is useful
for an in-house information channel, since the TV would always
select that Volume level when it is turned on. The range of values
are 0 - 63, 255. If 255 is selected, the current volume level will
be retained in memory when the TV is turned Off. At TV turn
On, Volume level is automatically set to the previous level.
Setting is retained in non-volatile memory.
0066.. PPoowweerr MMaannaaggeemmeenntt
Determines hours of no activity before automatic shutoff. The
POWER MANAGE function is for saving energy. If set to No,
Power Manage is disabled. Settings range from 1 ~ 7, repre-
senting the hours that the unit will remain On, unless there has
been activity from either the control panel or remote control.
Setting is retained in non-volatile memory.
0077.. KKeeyy MMaannaaggeemmeenntt
If set to 1, key defeat prevents the end user from accessing the
on-screen menus with the display front panel-MENU, SELECT,
and
FF
or
GG
button do not function. If set to 0, those keys do
function.
Note: The menus can always be accessed by pressing MENU
button on the remote.
Key management when enabled determines the level of control
that the guest has over the television. Key management has
four modes: (default is ‘0’)
0 = Television is unrestricted and responds to all commands.
1 = Key defeat ”prevents the television from responding
to “MENU”key presses on the front panel.
2 = “Key Lock ”prevents the television from responding to
any front panel key press.
3 = “System provider ”mode allows access to the menu
system from the front panel or remote control but
access is controlled as follows
* TV Guide if equipped – no access
* “Setup” – only access to main/pip input select screens
* “Video” – no access
* “Audio” – no access
* “Time” – only access to sleep timer
* “Option”– only access to aspect ratio, closed caption,
SimpLink
* “Lock” – full access
Setting is retained in non-volatile memory.
0088.. FFaaccttoorryy RReesseett
Set to 0 for normal.
Set to 1 to load presets to all of the previous item settings and
exit menu.
WARNING: Setting this to 1 will reload the factory defaults.
Setting is retained in non-volatile memory.
0099.. AAssppeecctt RRaattiioo
Selects default aspect ratio at power up, see settings below.
Set to 0 to disable. Aspect Ratio will stay at previous state.
Set to 1 “Set By Program”.
Set to 2 for 4:3.
Set to 3 for 16:9 (Factory Default).
Setting is retained in non-volatile memory.
Item Enable Disable Initial
Public Display Mode
Start Channel
Ch. Type
Major No.
Minor No.
Minimum Volume
Maximum Volume
Start Volume
Level
Power Management
Setting
Key Management
Factory Reset
Aspect Ratio
Yes No No
Yes No No
TV/CATV/DTV/CADTV TV
Subject to Ch. Type 2
Subject to Ch. Type 0
0 ~ 100 0
0 ~ 100 100
Yes No No
0 ~ 100
Yes No No
1 ~ 7 1
0 ~ 30
0 ~ 1 0
0 ~ 3 0