Filter
Top Products
22
206-4118
Use the MPI Cable to Connect the LT2002 Clone
Programmer to the Master TV MPI Port
If there is a good connection, “THE CLONE HAS CONTROL OF
THE TV” message will appear. Press any key on the Installer
Remote.
Learn Setup from Master TV
Press 1 to select the LEARN FROM TV option; then press ON/
OFF, POWER, or ENTER to go to the Memory Bank Selection
Menu. Select the Memory “Bank” in which you want to store the
Master TV Setup by pressing either Channel key repeatedly to
choose Memory 1, 2, or 3. (If you choose a Memory Bank that
has a Master device’s setup programmed into it, that setup will
be overwritten by the new Master TV’s Setup.) Once you select
the Clone Memory Bank, press ON/OFF, POWER, or ENTER.
The Clone Memory Bank you have selected will be shown. Press
ON/OFF or POWER to begin copying the Master TV Setup.
Set the Clock (Optional)
Set the time on a Master TV’s clock. (If the time has already
been copied from a TV into the Clone Programmer, you can set a
Master TV’s clock by copying the time from the Clone
Programmer.) The Clone Programmer can copy the current time
to both a Master TV and to the Clone’s internal clock—accurate
to within one minute. (Another reason that the Clone Programmer
should be equipped with fresh, high-quality alkaline batteries, is
for it to keep the time as accurately as possible.)
Since the Clone Programmer’s time cannot be set directly, the
current time needs to be copied from an LG TV equipped with
MPI input capability.
After the time is copied to the Clone Programmer, the current
time can then be transferred to another TV. (This can be a
Master TV or another TV which has already had the features
set up.)
LT2002 Clone Programmer Communication
Problems
• A slow flashing green light indicates that there are
communication problems between the TV and the
LT2002 Clone Programmer. If this is the case,
check for a damaged cable, poor contacts, or
other connection troubles.
• If the status indicator is red, the Programmer bat-
teries are low and should be replaced. Install four
(4) high-quality alkaline AA batteries.
Learning the Master TV Setup
Instructions for the Clone Programmer to Learn the Master TV Setup
This menu should appear by itself after the
LT2002 is connected to the TV MPI port.
LT2002 Cloning Connections / Learning Setup (Cont.)
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK= XX:XX
TV CLOCK= XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
CLONE SELECTION MENU
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
-TO CHANGE MENU ITEMS, PRESS
CHANNEL KEYS OR DIGITS.
-TO EXECUTE ITEM, PRESS ON/OFF,
POWER, OR ENTER
This menu should appear after any key
is pressed on the Installer Remote.