Filter
Top Products
CONNECTING THE 2:8 DISTRIBUTION AMPLIFIER FOR HDMI
OPERATING THE 2:8 DISTRIBUTION AMPLIFIER FOR HDMI
4
Connect the supplied cable from the HDTV HDMI source into the HDMI input port 1. 1
of the 2:8 Distribution Amplier For HDMI.
Connect a second HDTV HDMI source to HDMI input port 2 on the 2:8 Distribution 2.
Amplier For HDMI using a user supplied HDMI cable.
Connect the display(s) (up to eight) to the HDMI output port(s)* of the 2:8 3.
Distribution Amplier For HDMI using user supplied cable(s)
Plug the 24V DC power supply into the 2:8 Distribution Amplier For HDMI.4.
NOTE: *Display information (EDID) is sent from the display connected to
HDMI Output Port 1 to both of the sources connected to the 2:8 Distribution
Amplier for HDMI. If there is no display connected to HDMI Output Port 1, the
remaining HDMI Output Ports will be scanned in succession and use the rst
EDID that it detects. The source will output resolutions and timings according the
EDID that is being fed by the 2:8 Distribution Amplier for HDMI. Therefore, all of
the connected displays must be capable of accepting the timings and resolution
output by the source. It is recommended that the display with the lowest native
resolution be connected to HDMI output port 1. This is to ensure that a compatible
video signal will be able to be displayed on all connected monitors.
Switching between the inputs on the 2:8 Distribution Amplier for HDMI is done using
either the supplied RMT2-IR remote or the RJ11 to serial interface.
IR Remote
Pressing button one on the remote will select the HDMI source that is connected to
HDMI input port one. Pressing two on the remote will select the HDMI source that is
connected to HDMI input port two.
RJ11 To Serial Control Interface
Please see the diagram on page 7 for the RJ11 serial control interface pin conguration.
How to Connect the 2:8 Distribution Amplier For HDMI